CalderaSpas Moorea Manuel du propriétaire télécharger pdf (Page 23)

LIGHT CONTROL

The “LIGHT” button activates the light and controls the intensity. Pressing the “LIGHT” button operates the light as follows:

1st press of the “LIGHT” button – light will turn on to the maximum intensity.•

2nd press of the “LIGHT” button – light will turn to medium intensity.•

3rd press of the “LIGHT” button – light will turn to low intensity.•

4th press of the “LIGHT” button – light will turn off.•

If the light is left on, it will automatically turn off after 6 hours of continuous operation. The light symbol on the control panel will also turn off when the light is deactivated.

If the light will not turn on, make sure SPA LOCK is deactivated. SPA LOCK disables the functions on the control panel.

LIGHT CONTROL (SPAGLO

LIGHTING SYSTEM - OPTIONAL)

If your spa is equipped with the optional SpaGlo lighting system, the spa and grab bar will change colors via a color wheel. The color wheel may be stopped on any

color. The following buttons must be pressed to start and stop the wheel:

Press the “SET” + “LIGHT” button simultaneously while the light is on to start or stop the color wheel. The light symbol will flash on and off when the color wheel is on,

and the light symbol will display continuously when the wheel is stopped.

SUMMER MODE

Your Caldera

spa is equipped with a Summer Mode timer. The Summer Mode timer can be activated during extremely hot summer months if it

becomes difficult to maintain water temperatures low enough for comfort. Upon switching to the ON mode, the heater will immediately shut down

while the circulation pump (which can add heat to the water through normal operation) will remain on for approximately 5 minutes for heater cool-

down. Both heater and circulation pump will remain off for the next eight hours. Additionally, the summer mode display on the main control panel

will activate and remain active for as long as the summer mode is on. Following this eight hour period, the circulation pump, and heater will continue to turn off for an

eight hour period every day that the switch remains in the ON position. In this way, the amount of heat transferred to the spa water will be minimized. When the outside

temperatures begin to cool, the Summer Mode timer should be turned to the OFF position (the summer mode display on the main control panel shut off). This is the

efficient 24 hour circulation mode that keeps the heater operation and operating costs to a minimum during colder/heavier usage months.

NOTE: Whenever power is disconnected and then reconnected to the spa, the Summer Mode timer will reset starting with the 8-hour shutdown mode. If a different

8-hour shut down time is desired, deactivate the Summer Mode, then reactivate at the beginning of the desired 8-hour shut down time.

IMPORTANT: The Summer Mode will not lower the spa’s waters temperature below the ambient air temperature.

To activate the Summer Mode, simply follow these steps:

Set the temperature control to 80°F (27°C)1.

Onthecontrolpanel,simultaneouslypressandholdfor3seconds“TEMP▲“and“TEMP▼“toactivatetheSummerTimer.2.

The Summer Mode must be deactivated when cooler temperatures return. To do this, simply repeat step 2.

OPERATING INSTRUCTIONS

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

CalderaSpas Moorea Manuel du propriétaire Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol CalderaSpas Moorea